This modification loom deletes your EGR system. The loom is a fully molded and has a double-shielded construction. No tools are required to install the loom and it takes second to install. It is a simple plug and play design.

This cable is RoHS compliant, which is the international standard for electrical equipment and has an ip65+ water proof rating. It is a fully injected moulded module with double shielded loom for extra protection. The modification loom does not set off any engine codes.

If your vehicle has been tuned before running this cable, you may experience issues and I cannot guarantee that the cable will work to its full potential. Please keep this in mind before purchasing the cable.

Each product is inspected and Dielectric Grease is applied to the pins of the plugs (Male & Female), for information about the grease please refer to the images of the grease I use (Tube of grease not included just applied). I personally apply this dielectric grease on all my plugs on my cars to prevent any issues from the elements, mainly the corrosive properties of salt water. Even though all plugs in your engine bay are IP rated, there is still a chance of atmospheric pressure changes that can draw in contaminates. This is used in all marine applications as a precaution, my back ground is in marine craft and old habits are hard to kick.

What are the benefits?

EGR stands for "Exhaust Gas Recirculation". Put simply, it recycles your exhaust gases back into your engine in order to reduce the amount of gases and pollution put into the atmosphere by your car. Why should you care? Well, it means burnt, deoxygenated, hot air with carbon deposits being circulated through your intake system.

This results in premature wear and blockage to your intake system/motor.

Although the main purpose of this EGR delete is to deal with the issues above, the 4JJ1 motor EGR delete loom (which this product has been based off) had the following additional benefits:-

1. Performance gains (including better fuel consumption, smoother boost/power delivery).

2. Quieter running engine.

3. Clean, fresh air intake.

4. No limp mode or fault codes.

The EGR system is a necessary evil (to your engine) to reduce pollution emissions. As such, whilst it is good for the environment, it is bad for your engine.

There are some articles out there stating these EGR looms are bad for your engine, to clarify the loom does not change the engine coolant running temperature, it modifies the ambient air reading at the MAF Sensor. With these vehicles, the ambient air reading is only used for the EGR operations and therefore does not impact the air fuel ratios. From this, the only change that is made with air fuel ratios would be the more efficient running of the engine, due to not sucking in the exhaust gases.

What vehicles does this suit?

2015 - Current MQ Triton - 4N15 2.4L Engine

Fiat Fullback (4N15 HP)

2016 - Current Pajero Sport - 4N15 2.4L Engine

Important Information about EGR Delete Modules

We have prepared a number of blog posts regarding the EGR Delete Modules, including:-

- EGR Delete Modules myths busted

- Rough shut downs with EGR Delete Module plugged in

- EGR Delete Module -v- Catch Can

- EGR Delete Modules operating on Euro 5 Engines

- EGR Delete Modules and Error Codes

Installation

Tools required – No tools required

Installation Time - Approximately 1 minute

Difficulty – Plug and play